System information

Crestron 2-Series Control Systems Reference Guide
Reference Guide – DOC. 6256A 2-Series Control Systems • 117
2-Series Console Commands (continued)
SSL
Description: This command enables SSL protection on the processor. Entering the command without a parameter
displays the current setting.
Help Menu(s): Main, System
Syntax: SSL [OFF|SELF|CA]
Parameters: OFF – disable SSL on the processor (default)
SELF – enables SSL using self-signed certificates
CA - enables SSL using certificate from a certifying authority (CA)
Possible Source: RS-232
Minimum CUZ: 3.061
Processor Group: Ethernet Processors
STANDBY
Description: This command puts the panel into/out of standby mode. The panel goes blank during standby.
Help Menu(s): Device
Syntax: STANDBY [ON|OFF]
Parameters: ON – enables standby (backlight off)
OFF – disables standby (backlight on)
NOTE: No parameter enables standby.
Possible Source: RS-232, CTP, Telnet, User Program
Minimum CUZ: 1.017
Processor Group: Display Processors
STBYTO
Description: This command sets the standby timeout for the panel. Entering the command without a parameter displays
the current setting.
Help Menu(s): Device, Main
Syntax: STBYTO [timeout]
Parameters: timeout – number of seconds of inactivity before the panel enters standby (0 – 65535, where 0 (default)
disables the timeout)
Possible Source: RS-232, CTP, Telnet, User Program
Minimum CUZ: 1.017
Processor Group: Display Processors
SYSTEM
Description: This command initiates a firmware upgrade using Xmodem to transfer the new firmware to the system. The
user is prompted to start the Xmodem transfer (not allowed over a Telnet connection).
Help Menu(s): File, System
Syntax: SYSTEM
Parameters: none
Possible Source: RS-232, CTP
Minimum CUZ: 1.001
Processor Group: All Processors
(continued on next page)