System information

Crestron 2-Series Control Systems Reference Guide
Reference Guide – DOC. 6256A 2-Series Control Systems • 115
2-Series Console Commands (continued)
SELFTEST
Description: This command executes the system self test procedure. Feedback is provided.
Help Menu(s): Device
Syntax: SELFTEST
Parameters: none
Possible Source: RS-232, CTP, Telnet
Minimum CUZ: 1.001
Processor Group: All Processors
SENDKEY
Description: This command stores the e-Control2 activation key. The key should be obtained from Crestron. Entering the
command without a parameter displays the current setting.
Help Menu(s): Ethernet
Syntax: SENDKEY [key]
Parameters: key – the e-Control2 activation code obtained from Crestron
Possible Source: RS-232, CTP, Telnet, User Program
Minimum CUZ: 3.015
Processor Group: Ethernet Processors
SENDMODEMINITSTRING
Description: This command determines whether the modem initialization string is sent at startup. Entering the command
without a parameter displays the current setting.
Help Menu(s): File
Syntax: SENDMODEMINITSTRING
Parameters: ON – Sends the modem init string at startup.
OFF – Does not send the modem init string at startup.
Possible Source: RS-232, CTP, Telnet, User Program
Minimum CUZ: 3.129
Processor Group: All Processors
SERIAL
Description: This command sets the communication parameters for the COMPUTER (RS-232) port. New settings are
effective immediately. Entering the command without a parameter displays the current setting.
Help Menu(s): System
Syntax: SERial [baud,parity,databits,stopbits]
Parameters: baud – desired baud rate for the RS-232 port (110 through 115200)
parity – desired parity for the port (N, E, O)
databits – desired number of data bits (7,8)
stopbits – desired number of stop bits (1,2)
Possible Source: RS-232, CTP, Telnet, User Program
Minimum CUZ: 1.001
Processor Group: All Processors
(continued on next page)