System information

Crestron 2-Series Control Systems Reference Guide
Reference Guide – DOC. 6256A 2-Series Control Systems • 103
2-Series Console Commands (continued)
INITIALIZE
Description: This command erases the entire internal flash file system. It should only be used if the internal system has
been corrupted. Progress status messages appear until the command has completed. This command should
be used with caution and will clear the SIMPL Windows/SIMPL+ program and IP settings of the system.
Help Menu(s): File
Syntax: INITIALIZE
Parameters: none
Possible Source: RS-232, CTP, Telnet
Minimum CUZ: 1.001
Processor Group: All Processors
INPUT
Description: This command sets the input resolution for the selected CNX-DVP4/C2N-DVP4DI RGB input. Entering the
command without a parameter displays the current setting.
Help Menu(s): Device
Syntax: INPUT [input_select value|A|D|N|L]
Parameters: input_select – indicates which input to select
value – resolution value from 320 to 1920
A – auto calibrate this input
D – use default for this input
N – no HDTV Overscan for this input
L – lock Auto Calibrate On for this input
Possible Source: RS-232, CTP, Telnet, User Program
Minimum CUZ: 1.017
Processor Group: Display Processors
IPADDRESS
Description: This command sets the IP address of the control system. The value is stored in permanent memory and
requires a reboot before it is recognized. Entering the command without a parameter displays the current
setting.
Help Menu(s): Ethernet
Syntax: IPAddress [device_num ip_address]
Parameters: device_num – indicates device to be set (0 = LanA, 1 = LanB)
ip_address – the Internet Protocol (IP) address of the control system in dot decimal format
(eg. 255.255.255.255)
Possible Source: RS-232, CTP, Telnet, User Program
Minimum CUZ: 1.001
Processor Group: Ethernet Processors
(continued on next page)