System information

Crestron 2-Series Control Systems Reference Guide
Reference Guide – DOC. 6256A 2-Series Control Systems • 99
2-Series Console Commands (continued)
ERRLOG
Description: This command prints a list of the most recent errors. It wraps around at 100 so only the last 100 entries into
the log are displayed.
NOTE: Refer to “Appendix D: Error Message Definitions” on page 123 for a list and description of error
messages that can be generated by a 2-Series control system.
Help Menu(s): System
Syntax: ERRlog
Parameters: none
Possible Source: RS-232, CTP, Telnet, User Program
Minimum CUZ: 1.001
Processor Group: All Processors
ESTATUS
Description: This command displays the status of the Ethernet link (Link on/off, link speed, full duplex on/off). Also it
displays the settings for the Ethernet card.
Help Menu(s): Ethernet, System
Syntax: ESTatus
Parameters: none
Possible Source: RS-232, CTP, Telnet, User Program
Minimum CUZ: 1.001
Processor Group: Ethernet Processors
ETHERNET
Description: This command enables/disables the Ethernet card. A reboot is required before the command is effective.
Entering the command without a parameter displays the current setting.
Help Menu(s): Ethernet, System
Syntax: ETHERNET [ON | OFF]
Parameters: ON – enables the Ethernet card (default)
OFF – disables the Ethernet card
Possible Source: RS-232, CTP, Telnet, User Program
Minimum CUZ: 1.001
Processor Group: Ethernet Processors
(continued on next page)