System information

Crestron 2-Series Control Systems Reference Guide
Reference Guide – DOC. 6256A 2-Series Control Systems • 97
2-Series Console Commands (continued)
CURSOR
Description: This command sets the cursor options on the CNX-DVP4/ C2N-DVP4DI. Entering the command without a
parameter displays the current setting.
Help Menu(s): Device
Syntax: CURSOR [ON | OFF]
Parameters: ON – turns the display cursor on (default)
OFF – turns the display cursor off
Possible Source: RS-232, CTP, Telnet, User Program
Minimum CUZ: 1.017
Processor Group: Display Processors
DEFROUTER
Description: This command sets the IP address of the default router on the system. It is only necessary on networks
without automatic routing. The value is stored in permanent memory and requires a reboot before it is
recognized. Entering the command without a parameter displays the current setting.
Help Menu(s): Ethernet
Syntax: DEFRouter [device_num ip_address]
Parameters: device_num – indicates device to be set (must be 0 for backwards compatibility)
ip_address – the Internet Protocol (IP) address of the router node in dot decimal format (eg. 255.255.255.255)
Possible Source: RS-232, CTP, Telnet, User Program
Minimum CUZ: 1.001
Processor Group: Ethernet Processors
DELETE
Description: This command deletes file(s) from the file system. Wildcards are accepted and can be in the form of (*file, file,
and file).
NOTE: Compact flash directories can only use the standard DOS file wildcards.
Help Menu(s): File
Syntax: DELete filespec
Parameters: filespec – ASCII string contains the file name and/or wildcards
Possible Source: RS-232, CTP, Telnet, User Program
Minimum CUZ: 1.001
Processor Group: All Processors
DHCP
Description: This command selects whether dynamic IP addressing is supported using the DHCP protocol. If enabled, a
HOSTNAME should also be entered. Entering the command without a parameter displays the current setting.
Help Menu(s): Ethernet
Syntax: DHCP [ON | OFF | STATUS | REL_RENEW]
Parameters: ON – enables DHCP operation
OFF – disables DHCP operation (default)
STATUS – display the DHCP status
REL_RENEW – perform a release and renew function on the DHCP connection
Possible Source: RS-232, CTP, Telnet, User Program
Minimum CUZ: 3.044
Processor Group: Ethernet Processors
(continued on next page)