System information

Reference Guide Crestron 2-Series Control System
96 • 2-Series Control Systems Reference Guide – DOC. 6256A
2-Series Console Commands (continued)
CNETID
Description: This command changes the Cresnet ID for the processor. Changing the ID to anything other than 2 configures
the processor as a Cresnet slave. Entering the command without a parameter displays the current setting.
Help Menu(s): System
Syntax: CNETid [id]
Parameters: id - the ID of the system in hexadecimal notation (default: 2)
Possible Source: RS-232, CTP, Telnet, User Program
Minimum CUZ: 1.017 (CNX-DVP4, 3.044 (all others)
Processor Group: Cresnet Processors
COMCONSOLEMODE
Description: This command changes the default state of the QM-RMC or QM-RMCRX(-BA)’s shared console port. The
shared console port can operate as a console port for PC-to-Console communications or as a serial port.
Entering the command without a parameter displays the current setting.
Help Menu(s): System
Syntax: COMCONSOLEMODE
Parameters: ON – Locks COM B to console mode
OFF – Restore default COM B behavior
Possible Source: RS-232, CTP, Telnet, User Program
Minimum CUZ: 3.129
Processor Group: QuickMedia Processors
COMPACT
Description: This command reclaims internal flash file space by removing invalid (deleted) files from the system. The file
system is compacted to remove the holes left by the invalid files. The rest of the flash file space is cleared to
accept new files. The FREE command can be used to display the amount of file space that would be
reclaimed by the COMPACT command. Normally, the user need not initiate the COMPACT command. The
Crestron Viewport manages its usage.
Help Menu(s): File
Syntax: COMPACT
Parameters: none
Possible Source: RS-232, CTP, Telnet, User Program
Minimum CUZ: 1.001
Processor Group: All Processors
CTPPORT
Description: This command specifies the port number to be used for the CTP (Crestron Terminal Protocol) console
interface. It should only be used in the few cases where there is a conflict and used with extreme caution.
Entering the command without a parameter displays the current setting.
Help Menu(s): Ethernet
Syntax: CTPPORT [portnumber]
Parameters: portnumber – port number for console connection (default: 41795)
Possible Source: RS-232, CTP, Telnet, User Program
Minimum CUZ: 1.001
Processor Group: Ethernet Processors
(continued on next page)