Installation guide

Crestron MPC-M5 Media Presentation Controller™ M5
Operations & Installation Guide – DOC. 6955B Media Presentation Controller™ M5: MPC-M5  11
Installation
The following material and tools are required for installation of an MPC-M5:
 Standard 2-gang electrical box (not included)
 Philips screwdriver
 1/16” Allen wrench (included)
After the wiring has been installed and verified, use the following procedure to
install the MPC-M5 in a standard, 2-gang electrical box.
1. Turn system power OFF.
2. Use the four included 06-32 x 3/4” screws to attach the mounting plate to
the electrical box.
Attach the Mounting Plate
Mounting Plate
(4509215)
Screws (4) 06-32 x 3/4"
(2009211)
Ground wire
3. The ground wire from the mounting plate must be attached to an earth
ground (building steel).
NOTE: Ensure the unit is properly grounded.
4. Attach cables to the rear of the MPC-M5. Refer to “Hardware Hookup”
which starts on page 13.
5. Use the two included 04-40 x 1/4” screws to attach the MPC-M5 to the
mounting plate.
CAUTION: Excess wire that is pinched between the MPC-M5 and the
electrical box could short out. Make sure that all excess wire is completely
inside the electrical box and not between the box and the MPC-M5.