Specifications

infiNET™ Repeater Crestron C2N-MNETRPT
Add Repeater To infiNET Network
To add a repeater to an infiNET network, it must be “acquired” by a
gateway that is connected to a Crestron control system. Perform the
following to acquire a C2N-MNETRPT to a C2N-MNETGW:
1. Place the C2N-MNETGW that will communicate with the
C2N-MNETRPT in the Acquire mode by pressing the ACQUIRE
button or using Crestron Toolbox. For more information on the
C2N-MNETGW’s Acquire mode, refer to the latest revision of the
C2N-MNETGW Operations Guide (Doc. 6317).
NOTE: Only one C2N-MNETGW should be in the Acquire
mode.
2. Press SETUP on the C2N-MNETRPT to enter the Acquire mode.
The accompanying LED will illuminate indicating that it is
searching for a C2N-MNETGW in the Acquire mode. Once the
C2N-MNETRPT has been acquired, the MNET LED will light
and the SETUP LED will extinguish.
NOTE: To verify that the repeater has been acquired to the
correct gateway, use Crestron Toolbox’ network device tree (Tools
| Network Device Tree). For more information, refer to the
Crestron Toolbox help file.
NOTE: If the C2N-MNETRPT does not acquire with a
C2N-MNETGW, the SETUP LED will extinguish. If the
C2N-MNETRPT detects the C2N-MNETGW that it was
previously acquired to, the MNET LED will light.
3. Exit the Acquire mode on the C2N-MNETGW by pressing the
ACQUIRE button or using Crestron Toolbox as described in the
C2N-MNETGW Operations Guide.
10 • infiNET™ Repeater: C2N-MNETRPT Operations Guide – DOC. 6335A