Specifications

infiNET™ DIMMERS
Appendix: Wiring Diagrams
Following are wiring diagrams for circuits that may be found when installing infiNET dimmers:
Stand-Alone Installations
Figure 1: Wiring a CLW-DIM(S)XRF (CLW-DIMS1RF shown)
• Since a -DIMSXRF is installed without a slave, the blue lead of the -DIMS1/4RF must be capped.
If a neutral is not present in the wallbox, the wiring shown in the following diagram can be used.
Figure 2: Alternative Wiring of -DIM1RF, -DIMS1RF, -DIM4RF, and -DIMS4RF Where Neutral is Not Present
(Load-Fed Switch Loop)
In the above configuration:
• The white wire from the DIMSXRF to the load is coded HOT.
• Since a -DIMSXRF is installed without a slave, the blue lead of the -DIMS1/4RF must be capped.
• The minimum load requirement is 100W.
• Bulb noise may be present even when the load is off.
• Circuits with small magnetic low-voltage loads may not work.
9 • infiNET™ Wall Box Dimmer : CLW-DIM1/4RF, DIMS1/4RF, & SLVD1RF Installation Guide – DOC. 6292C