Specifications
infiNET™ DIMMERS
NOTE: Holding the button for a significant
time after the first flash may enter other modes.
If this is not desired, return the mode selection
switch to the “OFF” position without releasing
the button and repeat step 2.
After approximately ten seconds, the LED will
start to blink slowly and the dimmer will attempt
to acquire with a C2N-MNETGW that is in the
Acquire mode. The device is acquired when the
LED stops blinking and lights at the LOW
setting. After being acquired, the device will exit
the Acquire mode.
The dimmer will be acquired on the
C2N-MNETGW with an MNET ID value of 01.
If the dimmer was previously acquired on
another infiNET network, the dimmer will be
acquired on the C2N-MNETGW with its
previous MNET ID.
Problem Solving
Troubleshooting
The table after this paragraph provides corrective action
for possible trouble situations. If further assistance is
required, please contact a Crestron customer service
representative.
infiNET Dimmer Troubleshooting
TROUBLE POSSIBLE
CAUSE(S)
CORRECTIVE ACTION
Dimmer is
not
receiving
line power.
Verify that the dimmer is
properly connected to power
line and that the circuit
breaker is closed.
Dimmer
does not
function.
Load is not
connected.
Verify that load is operational
and that the mode selection
switch is in the RUN
position.
3. Take the C2N-MNETGW out of the Acquire
mode once all devices have been acquired. Refer
to the latest revision of the C2N-MNETGW
Operations Guide (Doc. 6317), which is
available from the Crestron website.
If the dimmer does not function after performing the
above corrective actions, restore the dimmer’s default
settings by moving the mode selection switch to the
“RUN” position. While holding the pushbutton (hold
“UP” on the -DIM1RF and -DIMS1RF, or hold Button 1
on the -DIM4RF or -DIMS4RF), move the mode
selection switch to the “SET” position and back to the
“RUN” position. Release the pushbutton. The LED will
flash once to confirm that the default values have been
restored.
For more information, refer to the latest version of the
infiNET Dimmers Operations Guide (Doc. 6396) which is
available from the Crestron website.
Further Inquiries
If you cannot locate specific information or have
questions after reviewing this guide, please take
advantage of Crestron's award winning customer service
team by calling the Crestron corporate headquarters at
1-888-CRESTRON [1-888-273-7876].
You can also log onto the online help section of the
Crestron website (
www.crestron.com/onlinehelp) to ask
questions about Crestron products. First-time users will
need to establish a user account to fully benefit from all
available features.
Future Updates
As Crestron improves functions, adds new features, and
extends the capabilities of the device, additional
information may be made available as manual updates.
These updates are solely electronic and serve as
intermediary supplements prior to the release of a
complete technical documentation revision.
Check the Crestron website periodically for manual
update availability and its relevance. Updates are
identified as an “Addendum” in the Download column.
Installation Guide – DOC. 6292C infiNET™ Wall Box Dimmer: CLW-DIM1/4RF, DIMS1/4RF, & SLVD1RF • 7