Specifications

infiNET™ DIMMERS
In this configuration:
• The white wire from the DIMSXRF to the load is coded HOT.
• The white wire of the -SLVD1RF must be capped.
• The white line between -DIMSXRF and the -SLVDRF must be capped on both ends.
• The minimum load requirement is 100W.
• Bulb noise may be present even when the load is off.
• The LED on an attached -SLVD1RF slave unit will not function.
• Circuits with small magnetic low-voltage loads may not work.
Figure 6: Alternative Wiring of -DIMSXRF (CLW-DIMS4RF shown) with -SLVD1RF Where Neutral is Not Present
(Center-Fed three-way system)
In the above configuration:
• The white wire from the -DIMSXRF to the load is coded HOT.
• The minimum load requirement is 100W.
• Bulb noise may be present even when the load is off.
• Circuits with small magnetic low-voltage loads may not work.
Installation Guide – DOC. 6292C infiNET™ Wall Box Dimmer: CLW-DIM1/4RF, DIMS1/4RF, & SLVD1RF • 11