Installation guide

InfiNET EX Wireless Gateway Crestron CEN-RFGW-EX
22 • infiNET EX Gateway: CEN-RFGW-EX Operations & Installation Guide – DOC. 6706G
CEN-RFGW-EX Troubleshooting (Continued)
TROUBLE POSSIBLE
CAUSE(S)
CORRECTIVE
ACTION
CEN-RFGW-EX
is not shown on
Network Device
Tree when
polling through
Toolbox. Other
devices are
reported.
Network wiring is
incorrect.
Check network cabling
for solid connections
and correct pinouts.
CEN-RFGW-EX is
damaged.
Contact a Crestron
customer service
representative.
Multiple infiNET
EX devices only
operate one at a
time.
Multiple infiNET EX
devices are set to
the same RF ID.
Use Crestron Toolbox
to poll the network.
Check the RF ID for
the device, then refer
to the “Setup” section
of the guide for the
device to set its RF ID
to match the RF ID in
the SIMPL program.
Check Network Wiring
Use the
Right Wire
In order to ensure optimum performance over the full range of the
installation topology, use Crestron Certified Wire only. Failure to do so
may incur additional charges if support is required to identify
performance deficiencies because of using improper wire.
Calculate
Power
CAUTION: Use only Crestron power supplies for Crestron equipment.
Failure to do so could cause equipment damage or void the Crestron
warranty.
CAUTION: Provide sufficient power to the system. Insufficient power
can lead to unpredictable results or damage to the equipment. Please use
the Crestron Power Calculator to help calculate how much power is
needed for the system (
www.crestron.com/calculators).
When calculating the length of wire for a particular Cresnet run, the
wire gauge and the Cresnet power usage of each network unit to be