Installation guide

Crestron CEN-RFGW-EX infiNET EX Wireless Gateway
Operations & Installation Guide – DOC. 6706G infiNET EX Gateway: CEN-RFGW-EX • 17
Crestron
Studio /
VT Pro-e
Upload the Crestron Studio (or VT Pro-e) file for the RF device using
Crestron Studio (or VT Pro-e) or Crestron Toolbox.
Firmware
Check the Crestron Web site to find the latest firmware. (New users may
be required to register to obtain access to certain areas of the site,
including the FTP site.)
Upgrade CEN-RFGW-EX firmware via Crestron Toolbox.
1. Establish communication with the CEN-RFGW-EX and display
the “System Info” window.
2. Select Functions | Firmware… to upgrade the CEN-RFGW-EX
firmware.
NOTE: Minimum firmware version is 2.001.0003 or later.
Program Checks
Actions that can be performed on the CEN-RFGW-EX vary depending
on whether it is connected via Cresnet or Ethernet.
Cresnet
Connections
For Cresnet connections, using Crestron Toolbox, display the network
device tree (Tools | Network Device Tree View) to show all network
devices connected to the control system. Right-click on the
CEN-RFGW-EX to display actions that can be performed on the
CEN-RFGW-EX.
Ethernet
Connections
For Ethernet connections, display the “System Info window (Tools |
System Info) and select the Functions menu to display actions that can
be performed on the CEN-RFGW-EX.
Be sure to use Crestron Toolbox to create the CEN-RFGW-EX IP table.
1. Select Functions | IP Table Setup.
2. Add, modify or delete entries in the IP table. The CEN-RFGW-EX
can have only one IP table entry.
3. A defined IP table can be saved to a file or sent to the device.
Edit the control system’s IP table to include an entry for the
CEN-RFGW-EX. The entry should list the CEN-RFGW-EX’s IP ID
(specified on the CEN-RFGW-EX’s IP table) and the internal gateway IP
address 127.0.0.1.
NOTE: Only one IP table entry is allowed. The unit can talk to only one
processor over IP.