Installation guide

InfiNET EX Wireless Gateway Crestron CEN-RFGW-EX
10 • infiNET EX Gateway: CEN-RFGW-EX Operations & Installation Guide – DOC. 6706G
Connectors, Controls & Indicators (Continued)
# CONNECTORS
1
,
CONTROLS &
INDICATORS
DESCRIPTION
7 LAN PoE
2, 3
Green
LED
Yellow
LED
Pin 8
Pin 1
(1) 8-wire RJ-45 female, with
two LED indicators;
10BASE-T/100BASE-TX
Ethernet port;
Power over Ethernet compliant;
Green LED indicates link
status;
Yellow LED indicates Ethernet
activity
PIN
SIGNAL
PIN
SIGNAL
1
TX +
5
N/C
2
TX -
6
RC -
3
RC +
7
N/C
4
N/C
8
N/C
8 NET
2
G Z Y
24
(1) 4-pin 3.5 mm detachable
terminal block;
Cresnet slave port, connects to
Cresnet control network
24: Power (24 Volts DC)
Y: Data
Z: Data
G
: Ground
1. An interface connector for the NET port is provided with the unit.
2. Power should be supplied through either the LAN PoE port or the NET port but
not both.
3. The pin out table indicates signal connections. DC power applied by Ethernet
power sourcing equipment (PSE) can connect to either signal pins or N/C pins.