Crestron IM-WCVP iMedia Wall Plate Computer Center with Video Control Panel Operations & Installation Guide
This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON All brand names, product names and trademarks are the property of their respective owners. ©2006 Crestron Electronics, Inc.
Crestron IM-WCVP iMedia Wall Plate Control Panel Contents iMedia Wall Plate Computer Center with Video Control Panel: IM-WCVP 1 Introduction......................................................................................1 Features and Functions ..........................................................1 Application ............................................................................3 Specifications.........................................................................
Crestron IM-WCVP iMedia Wall Plate Control Panel iMedia Wall Plate Computer Center with Video Control Panel: IM-WCVP Introduction Features and Functions • Control panel for use with the IM-WCVI iMedia Wall Plate Computer Center with Video Interface1 • Connects to IM-WCVI to create IM-WCCV-S Wall Plate Computer Center with Video using CresCAT™-IM iMedia cable or other high quality CAT5 cable (up to 40 feet) 2 • Controls volume, source selection, and power for iMedia systems • Mounts in a standard, 2½ inch
iMedia Wall Plate Control Panel Crestron IM-WCVP 20-bit, 48 kHz resolution. Control and power signals are also contained on the same wire, eliminating the need for separate control or power cables. * For iMedia use CresCAT-IM cable, or quality CAT5e/CAT6 cable having a maximum delay skew of 15ns per 100m. 2-Piece Wall Plate Multimedia Interface The IM-WCCV-S is an iMedia (IM) transmitter featuring separate wall plates for interface and control.
Crestron IM-WCVP iMedia Wall Plate Control Panel Application The IM-WCVP is part of the IM-WCCV-S iMedia transmitter. As shown in the following diagram, iMedia transmitters provide input points for video and PC sources on an iMedia receiver.
iMedia Wall Plate Control Panel Crestron IM-WCVP Specifications Specifications for the IM-WCVP are listed in the following table. IM-WCVP Specifications SPECIFICATION Power Requirements Environmental Temperature Humidity Enclosure Dimensions Height Width Depth Weight 4 • iMedia Wall Plate Control Panel: IM-WCVP DETAILS Power is provided by the iMedia receiver via the IM transport 41° to 104°F (5° to 40°C) 10% to 90% RH (non-condensing) Requires 2.5 inch deep singlegang electrical box 4.50 in (11.
Crestron IM-WCVP iMedia Wall Plate Control Panel Physical Description This section provides information on the connections, controls, and indicators available on your IM-WCVP. IM-WCVP Physical View IM-WCVP Overall Dimensions 2.75 in. (6.99 cm) 2.10 in. (5.34 cm) 1 2 4 4.50 in. (11.43 cm) 5 3 FRONT 2.70 in (6.85 cm) Operations & Installation Guide – DOC.
iMedia Wall Plate Control Panel Crestron IM-WCVP Connectors, Controls, & Indicators * # CONNECTORS, CONTROLS, & INDICATORS DESCRIPTION 1 VOLUME CONTROL KNOB Turn clockwise to raise the volume of the selected input; turn counterclockwise to lower the volume of the selected input. 2 VIDEO BUTTON 3 PC BUTTON 4 GROUND WIRE 5 TO IM-WCVI Turns on the system and selects the source connected to the VIDEO input of the IM-WCVI.
Crestron IM-WCVP iMedia Wall Plate Control Panel Industry Compliance As of the date of manufacture, the IM-WCVP has been tested and found to comply with specifications for CE marking and standards per EMC and Radiocommunications Compliance Labelling. NOTE: This device complies with part 15 of the FCC rules.
iMedia Wall Plate Control Panel Crestron IM-WCVP Setup Network Wiring When wiring the network, consider the following: • Use Crestron Certified Wire. • Use Crestron power supplies for Crestron equipment. Installation The IM-WCVP is designed to mount in a standard 2.5-inch (6.35 cm) deep, single-gang, electrical box.
Crestron IM-WCVP iMedia Wall Plate Control Panel Hardware Hookup Ventilation To prevent overheating, do not operate this product in an area that exceeds the environmental temperature range listed in the table of specifications. Consideration must be given if installed in a closed or multi-unit rack assembly since the operating ambient temperature of the rack environment may be greater than the room ambient. Contact with thermal insulating materials should be avoided on all sides of the unit.
iMedia Wall Plate Control Panel Crestron IM-WCVP Operation The IM-WCVP can be used to turn a system on or off, select a source, or adjust volume. Turn on the System Press the PC button to turn on the system with the PC signals routed to the iMedia receiver or press the VIDEO button to turn on the system with the video signals routed to the iMedia receiver. The associated LED will light to indicate the selected source.
Crestron IM-WCVP iMedia Wall Plate Control Panel Problem Solving Troubleshooting The following table provides corrective action for possible trouble situations. If further assistance is required, please contact a Crestron customer service representative. IM-WCVP Troubleshooting TROUBLE SOURCE LED does not illuminate. POSSIBLE CAUSE(S) Not receiving power. Incorrect power supply. Source is not selected. No video output displayed. Incorrect cable connection.
iMedia Wall Plate Control Panel Crestron IM-WCVP IM-WCVP Troubleshooting (Continued) TROUBLE POSSIBLE CAUSE(S) CORRECTIVE ACTION No audio output. Incorrect cable connection. Video from RGB source is garbled or no output. Incorrect cable connections. Button does not function when pressed. Incorrect cable connection. Other functions operate, but does not control the projector. Incorrect connections to projector. Verify computer audio cable connection. Verify video input’s audio cable connection.
Crestron IM-WCVP iMedia Wall Plate Control Panel Reference Documents The latest version of all documents mentioned within the guide can be obtained from the Crestron website (http://www.crestron.com/manuals). This link will provide a list of product manuals arranged in alphabetical order by model number.
iMedia Wall Plate Control Panel Crestron IM-WCVP Return and Warranty Policies Merchandise Returns / Repair Service 1. No merchandise may be returned for credit, exchange, or service without prior authorization from CRESTRON. To obtain warranty service for CRESTRON products, contact an authorized CRESTRON dealer. Only authorized CRESTRON dealers may contact the factory and request an RMA (Return Merchandise Authorization) number.
Crestron IM-WCVP iMedia Wall Plate Control Panel This page is intentionally left blank. Operations & Installation Guide – DOC.
Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888.CRESTRON Fax: 201.767.7576 www.crestron.com Operations & Installation Guide – DOC. 6489 (2015097) 05.06 Specifications subject to change without notice.
