Installation guide

Crestron IM-WCVI-M iMedia Wall Plate Computer & Video Center Interface
iMedia Wall Plate Computer &
Video Center Interface:
IM-WCVI-M
Introduction
The IM-WCVI-M is the interface panel portion of a complete IM-WCCV-S-M
iMedia Wall Plate Computer & Video Center. The IM-WCCV-S-M includes one (1)
IM-WCVI-M and one (1) IM-WCVP-M control panel. These two components are
designed to function together as a single product and cannot be used individually.
Features and Functions
• Separate interface panel for use with the IM-WCVP-M iMedia Wall Plate
Computer & Video Center Control Panel
1
• Connects to IM-WCVP-M to create IM-WCCV-S-M Wall Plate Computer
Center with Video using CresCAT™-IM iMedia cable (up to 40 feet)
2
• Connects PC and composite video (with audio) sources to iMedia systems
• Mounts in a standard, 2½ inch deep, double-gang electrical box
1. The IM-WCVI-M is part of the IM-WCCV-S-M. It must be used with the IM-WCVP-M.
2. For more information on CresCAT-IM cable, refer to “IM Wiring” on page 8.
The iMedia Transport
The iMedia transport utilizes a single CAT5e* type cable to transmit computer RGB,
video, and stereo audio signals to a single projector or plasma display. A typical
XGA signal (1024 X 768 pixels at 60Hz) can be transmitted up to 84 feet using
iMedia, while higher resolutions up to 1600 x 1200 can be handled over shorter
distances. Audio is transmitted digitally at 20-bit, 48 kHz resolution. Control and
power signals are also contained on the same wire, eliminating the need for separate
control or power cables.
* For optimum performance, Crestron strongly recommends using CRESCAT-IM cable, available
from Crestron. Other high-quality/low skew (15 ns per 100 m maximum) CAT5e/CAT6 wiring may
also be used with varying performance.
Operations & Installation Guide – DOC. 6622A iMedia Wall Plate Interface: IM-WCVI-M • 1