Installation guide

Crestron IM-WCVP-M iMedia Wall Plate Control Panel
Operation
The IM-WCVP-M can be used to turn a system on or off, select a source,
adjust volume, or adjust the microphone level.
Turn on the
System
Press the PC button to turn on the system with the PC signals routed to
the iMedia receiver or press the VIDEO button to turn on the system
with the video signals routed to the iMedia receiver. The associated LED
will light to indicate the selected source.
Select a
Source
Press the PC button to route PC signals to the iMedia receiver or press
the VIDEO button to route video signals to the iMedia receiver The
associated LED will light to indicate the selected source.
Adjust Volume
Turn the volume knob clockwise to raise the volume of the selected
input; turn counterclockwise to lower the volume of the selected input.
Adjust
Microphone
Level
The microphone level is adjusted by holding either the PC button or the
VIDEO button and turning the rotary VOLUME knob, depending on
the source that is currently selected. For example, if the PC source is
selected you would need to hold the PC button while adjusting the
VOLUME knob to adjust the microphone.
When the PC button or VIDEO button is released after adjusting the
microphone volume level, the selected source will remain at the volume
setting it had prior to the adjustment of the microphone volume.
Control over the selected source volume level is regained by adjusting
the VOLUME knob without holding down either the PC button or the
VIDEO button. The selected source volume level will gradually ramp
up or down to the selected volume level positioned on the VOLUME
knob.
Turn off the
System
Press and hold the selected source button for five seconds. The source
button LED will flash and then turn off.
Operations & Installation Guide – DOC. 6623A Wall Plate Control Panel: IM-WCVP-M
• 11