Crestron IM-WCVP-M iMedia Wall Plate Computer & Video Center Control Panel Operations & Installation Guide
This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON All brand names, product names and trademarks are the property of their respective owners. ©2007 Crestron Electronics, Inc.
Crestron IM-WCVP-M iMedia Wall Plate Control Panel Contents iMedia Wall Plate Computer & Video Center Control Panel: IM-WCVP-M 1 Introduction......................................................................................1 Features and Functions ..........................................................1 Application ............................................................................3 Internal Block Diagram .........................................................4 Specifications............
Crestron IM-WCVP-M iMedia Wall Plate Control Panel iMedia Wall Plate Computer & Video Center Control Panel: IM-WCVP-M Introduction The IM-WCVP-M is the control panel portion of a complete IM-WCCV-S-M iMedia Wall Plate Computer & Video Center. The IM-WCCV-S-M includes one (1) IM-WVCP-M and one (1) IM-WCVI-M interface panel. These two components are designed to function together as a single product and cannot be used individually.
iMedia Wall Plate Control Panel Crestron IM-WCVP-M The iMedia Transport The iMedia transport utilizes a single CAT5e* type cable to transmit computer RGB, video, and stereo audio signals to a single projector or plasma display. A typical XGA signal (1024 X 768 pixels at 60Hz) can be transmitted up to 84 feet using iMedia, while higher resolutions up to 1600 x 1200 can be handled over shorter distances. Audio is transmitted digitally at 20-bit, 48 kHz resolution.
Crestron IM-WCVP-M iMedia Wall Plate Control Panel Application The IM-WCVP-M is part of the IM-WCCV-S-M iMedia transmitter. As shown in the following diagram, iMedia transmitters provide input points for video and PC sources on an iMedia receiver. iMedia System Diagram Operations & Installation Guide – DOC.
iMedia Wall Plate Control Panel Crestron IM-WCVP-M Internal Block Diagram The following diagram represents the abilities of the IM-WCCV-S-M. Internal Block Diagram of the IM-WCCV-S-M VGA Video Switch VIDEO BUTTON PC LED BUTTON VIDEO Microprocessor Power Power Supply IM Output LED VOLUME STEREO AUDIO Audio Switch A/D COMPUTER AUDIO Specifications Specifications for the IM-WCVP-M are listed in the following table.
Crestron IM-WCVP-M iMedia Wall Plate Control Panel IM-WCVP-M Specifications (Continued) SPECIFICATION Dimensions Height Width Depth Weight DETAILS 4.50 in (11.43 cm) 2.75 in (6.99 cm) 2.70 in (6.85 cm) 6.2 oz (176 g) Physical Description This section provides information on the connections, controls, and indicators available on your IM-WCVP-M. IM-WCVP-M Physical View Operations & Installation Guide – DOC.
iMedia Wall Plate Control Panel Crestron IM-WCVP-M IM-WCVP-M Overall Dimensions 2.75 in. (6.99 cm) 2.10 in. (5.34 cm) 1 4 2 4.50 in. (11.43 cm) 5 3 2.70 in (6.85 cm) FRONT REAR Connectors, Controls, & Indicators # CONNECTORS, CONTROLS, & INDICATORS DESCRIPTION 1 VOLUME (1) Rotary knob, adjusts audio levels for local input. Microphone level is adjusted by holding the VIDEO or PC button and turning the VOLUME knob.
Crestron IM-WCVP-M iMedia Wall Plate Control Panel Connectors, Controls, & Indicators (Continued) # CONNECTORS, CONTROLS, & INDICATORS DESCRIPTION 5 TO IM-WCVI-M2, 3 (1) 8-wire RJ-45 female; Connects to IM input port of an iMedia receiver via CresCAT-IM cable; Maximum Cable Length: 40 ft (12.2 m) 1. Ensure that the unit is properly grounded. 2. The eight-pin RJ-45 TO IM-WCVI-M port accepts CresCAT-IM carrying control signals. Refer to the following table for connector pinouts.
iMedia Wall Plate Control Panel Crestron IM-WCVP-M Industry Compliance As of the date of manufacture, the IM-WCVP-M has been tested and found to comply with specifications for CE marking and standards per EMC and Radiocommunications Compliance Labelling. NOTE: This device complies with part 15 of the FCC rules.
Crestron IM-WCVP-M iMedia Wall Plate Control Panel Setup Network Wiring When wiring the network, consider the following: • Use Crestron Certified Wire. • Use Crestron power supplies for Crestron equipment. Installation The IM-WCVP-M is designed to mount in a standard 2.5-inch (6.35 cm) deep, single-gang, electrical box.
iMedia Wall Plate Control Panel Crestron IM-WCVP-M Hardware Hookup Make the necessary connections as called out in the illustration that follows this paragraph. Turn on the system only after all connections have been made. Hardware Connections for the IM-WCVP-M TO IM-WCVI-M: CRESCAT-IM CONNECTION TO IM-WCVI-M GROUND NOTE: For optimum performance, Crestron strongly recommends using CRESCAT-IM cable, available from Crestron.
Crestron IM-WCVP-M iMedia Wall Plate Control Panel Operation The IM-WCVP-M can be used to turn a system on or off, select a source, adjust volume, or adjust the microphone level. Turn on the System Press the PC button to turn on the system with the PC signals routed to the iMedia receiver or press the VIDEO button to turn on the system with the video signals routed to the iMedia receiver. The associated LED will light to indicate the selected source.
iMedia Wall Plate Control Panel Crestron IM-WCVP-M Problem Solving Troubleshooting The following table provides corrective action for possible trouble situations. If further assistance is required, please contact a Crestron customer service representative. IM-WCVP-M Troubleshooting TROUBLE SOURCE LED does not illuminate. No video output displayed. POSSIBLE CAUSE(S) Not receiving power. Incorrect power supply. Source is not selected. Incorrect cable connection. No audio output.
Crestron IM-WCVP-M iMedia Wall Plate Control Panel IM-WCVP-M Troubleshooting (Continued) TROUBLE POSSIBLE CAUSE(S) CORRECTIVE ACTION Video from RGB source is garbled or no output. Incorrect cable connections. Button does not function when pressed. Other functions operate, but does not control the projector. Incorrect cable connection. Verify 15-pin computer cable connection. Verify iMedia output cable connections. Verify maximum iMedia cable length. Adjust delay on iMedia receiver.
iMedia Wall Plate Control Panel Crestron IM-WCVP-M Further Inquiries If you cannot locate specific information or have questions after reviewing this guide, please take advantage of Crestron's award winning customer service team by calling the Crestron corporate headquarters at 1-888-CRESTRON [1-888-273-7876]. For assistance in your local time zone, refer to the Crestron website (www.crestron.com/offices) for a listing of Crestron worldwide offices.
Crestron IM-WCVP-M iMedia Wall Plate Control Panel Return and Warranty Policies Merchandise Returns / Repair Service 1. No merchandise may be returned for credit, exchange or service without prior authorization from CRESTRON. To obtain warranty service for CRESTRON products, contact an authorized CRESTRON dealer. Only authorized CRESTRON dealers may contact the factory and request an RMA (Return Merchandise Authorization) number.
Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888.CRESTRON Fax: 201.767.7576 www.crestron.com Operations & Installation Guide – DOC. 6623A (2018826) 09.07 Specifications subject to change without notice.
