Installation guide

QuickMedia
®
Computer Centers Crestron QM-FBCC/WCC-1
16  QuickMedia
®
: QM-FBCC/WCC-1 Operations & Installation Guide – DOC. 6716B
Installation
The QM-FBCC/WCC-1 should be used in a well-ventilated area. The
venting holes should not be obstructed under any circumstances.
To prevent overheating, do not operate this product in an area that
exceeds the environmental temperature range listed in the table of
specifications.
The following tools and accessories are required for installation of a
QM-FBCC/WCC-1:
 Hubbell
®
SystemOne
®
floor box S1SP plate (for QM-FBCC-1,
not supplied)
 Standard 1-gang electrical box (for QM-WCC-1, not supplied)
 Decorator style or equivalent wall plate (for QM-WCC-1, not
supplied)
 Flat head screwdriver (not supplied)
 Two #06-32 x 1” screws (included)
 Insert, black or white (included)
After Cresnet and QM wiring has been installed and verified, use the
following procedure to install the QM-FBCC/WCC-1.
1. Turn system power OFF.
2. Connect the Cresnet and QM cables to the QM-FBCC/WCC-1’s
Cresnet and QM ports, respectively.
3. Attach the QM-FBCC/WCC-1 to the floor box or electrical box
using the two supplied #06-32 x 1” screws.
CAUTION: Excess wire that is pinched between the
QM-FBCC/WCC-1 and the floor box or electrical box could short out.
Make sure all excess wire is completely inside the floor box or electrical
box and not between the box and the QM-FBCC/WCC-1.
4. For the QM-WCC-1, attach the wall plate using the screws that
came with the wall plate.
5. Remove the backing, which covers the adhesive, on the insert and
attach the insert to the QM-FBCC/WCC-1, as shown in the
illustrations on the following pages.
6. Turn system power ON.