Installation guide

iMedia Table Mount Computer Center Crestron IM-TCC
AUDIO
The 3.5 mm computer audio connector provides an unbalanced stereo line-level
audio input.
● Maximum input level 2 V
RMS
● Input impedance 10k Ohms
COMPUTER
This female DB15HD connector is used for connecting a computer’s RGB
video output to the display device. A corresponding 3.5mm mini-jack is
provided for the computer sound card output.
● Maximum input voltage 1.0 V
p-p
(R/G/B), 5.0 V
p-p
(H/V)
● Input Impedance 75 Ohms (R/G/B), 1 k Ohms (H/V)
Refer to the following table for pin-assignments.
RGB DB15HD Pin Assignments
PIN FUNCTION PIN FUNCTION
1 Red Video 9 No Connect
2 Green Video 10 Ground
3 Blue Video 11 No Connect
4 Reserved 12 Monitor Sense 1
5 Ground 13 Horizontal Sync
6 Red Ground 14 Vertical Sync
7 Green Ground 15 Monitor Sense 2
8 Blue Ground
IM
IM
1
This eight-pin RJ-45 transport port allows connection of the iMedia cable. It
carries audio and video signals over CresCAT-IM cable to an iMedia receiver
(IM-RX1 or IM-RX3). For more information on iMedia cable length refer to the
chart on page 3.
NOTE: Always use CresCAT-IM cable to make iMedia connections.
Industry Compliance
As of the date of manufacture, the IM-TCC has been tested and found to comply
with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling.
NOTE: This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
6 • iMedia Table Mount Computer Center: IM-TCC Operations & Installation Guide - DOC. 6383