Installation guide

Crestron IM-TCC-M iMedia Table Mount Computer Center
iMedia Table Mount Computer
Center: IM-TCC-M
Introduction
Features and Functions
• A flexible computer interface for portable, lectern mount or under table
installation
• Streamlined user controls for foolproof operation
• iMedia transport for fast and easy single cable installation
• Supports XGA resolution up to 84 feet (25.6 meters), UXGA maximu
m
up to 34 feet (10.4 meters)
• Complete system setup in minutes using iMedia Wizard software
The iMedia Transport
The iMedia (IM) transport utilizes a single CAT5e* type cable to transmit computer
RGB, video and stereo audio signals to a single projector or plasma display. A
typical XGA signal (1024 x 768 pixels at 60 Hz) can be transmitted up to 84 feet
(25.6 meters) using iMedia, while higher resolutions up to 1600 x 1200 can be
handled over shorter distances. Audio is transmitted digitally at 20-bit, 48 kHz
resolution. Control and power signals are also contained on the same wire,
eliminating the need for separate control or power cables.
* For optimum performance, Crestron strongly recommends using CRESCAT-IM cable, available from
Crestron. Other high quality, low skew (15 ns per 100 m maximum) CAT5e/CAT6 wiring may also
be used with varying performance.
Table Mount Computer Interface
The IM-TCC-M is an iMedia transmitter designed to install flush in any flat surface
or underneath a tabletop using the mounting brackets provided. RGB and stereo
audio inputs on the front of the IM-TCC-M provide for connection to the output of a
computer source. Installing wiring for the IM-TCC-M is extremely simple requiring
just a single CrestCAT-IM cable for audio and video. Up to three IM-TCC-Ms or
other IM transmitters may be installed as part of a complete system to provide
multiple input locations within the room.
Operations & Installation Guide – DOC. 6636A iMedia Table Mount Computer Center: IM-TCC-M • 1