Installation guide

Crestron IM-TCC-M iMedia Table Mount Computer Center
NOTE: Do not over-tighten the screws as this may damage the surface and/or the
unit.
NOTE: To prevent overheating, do not operate this product in an area that exceeds
the environmental temperature range listed in the specifications table. Consideration
must be given if installed in a closed or multi-unit rack assembly, inside a closed
desk, or in a closed podium since the operating ambient temperature of these
environments may be greater than the room ambient. Contact with thermal insulating
materials should be avoided on all sides of the unit.
Hardware Hookup
Make the necessary connections as called out in the illustrations that follow this
paragraph. Turn on the system only after all connections have been made.
Hardware Connections for the IM-TCC-M (Front)
AUDIO:
AUDIO INPUT
FROM
COMPUTER
COMPUTER:
RGB INPUT
FROM
COMPUTER
Hardware Connections for the IM-TCC-M (Rear)
IM:
iMEDIA OUTPUT PORT
CARRIES AUDIO AND RGB
SIGNALS TO IM RECEIVER
GROUND
NOTE: For optimum performance, Crestron strongly recommends using
CRESCAT-IM cable, available from Crestron. Other high quality, low skew (15 ns
per 100 m maximum) CAT5e/CAT6 wiring may also be used with varying
performance.
NOTE: Ensure the unit is properly grounded.
Operations & Installation Guide – DOC. 6636A iMedia Table Mount Computer Center: IM-TCC-M • 11