Crestron IM-FTCC-M iMedia Fliptop Computer Center Operations & Installation Guide
This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON All brand names, product names and trademarks are the property of their respective owners. ©2007 Crestron Electronics, Inc.
Crestron IM-FTCC-M iMedia FlipTop Computer Center Contents iMedia FlipTop Computer Center: IM-FTCC-M 1 Introduction ..........................................................................................................1 Features and Functions...........................................................................1 Applications ...........................................................................................3 Internal Block Diagram.........................................................
Crestron IM-FTCC-M iMedia FlipTop Computer Center iMedia FlipTop Computer Center: IM-FTCC-M Introduction Crestron's iMedia provides an extremely simple and affordable multimedia presentation solution for small conference rooms and training rooms. No comparable solution comes close to matching iMedia's speed and ease of installation, intuitive operation, and incredibly low cost.
iMedia FlipTop Computer Center Crestron IM-FTCC-M The iMedia Transport The iMedia (IM) transport utilizes a single CAT5e* type cable to transmit computer RGB, video, and stereo audio signals to a single projector or plasma display. A typical XGA signal (1024 X 768 pixels at 60 Hz) can be transmitted up to 84 feet (25.6 m) using iMedia, while higher resolutions up to 1600 x 1200 can be handled over shorter distances. Audio is transmitted digitally at 20-bit, 48 kHz resolution.
Crestron IM-FTCC-M iMedia FlipTop Computer Center Applications The IM-FTCC-B is an IM transmitter. As shown in the following diagram, IM transmitters provide input points for video and PC sources on an IM receiver. Typical Installation for Media Presentation (IM-FTCC-M is shown at Bottom) Operations & Installation Guide – DOC.
iMedia FlipTop Computer Center Crestron IM-FTCC-M Internal Block Diagram The following diagram represents the signal routing and functions of the IM-FTCC-M. Internal Block Diagram of the IM-FTCC-M VGA BUTTON SELECT Microprocessor Power Power Supply IM Output LED VOLUME COMPUTER AUDIO A/D Specifications Specifications for the IM-FTCC-M are given in the following table.
Crestron IM-FTCC-M iMedia FlipTop Computer Center IM-FTCC-M Specifications (Continued) SPECIFICATION DETAILS Dimensions IM-FTCC-M Height Width Depth 4.63 in (11.76 cm) with lid closed 6.84 in (17.38 cm) 5.62 in (14.28 cm) without mounting brackets IMI-FTCC-M Height Width Depth 5.43 in (13.79 cm) with lid closed 8.34 in (21.19 cm) 6.20 in (15.74 cm) without mounting brackets Weight IM-FTCC-M IMI-FTCC-M 3.65 lbs (1.66 kg) with cables 4.42 lbs (2.
iMedia FlipTop Computer Center IM-FTCC-M Open Top View Crestron IM-FTCC-M IMI-FTCC-M Open Top View SELECT IM-FTCC-M Physical Dimensions – Top View IMI-FTCC-M Physical Dimensions – Top View 5.62 in (14. 28 cm) 6. 20 in (15.74 cm ) 6.84 in (17. 38 cm) 8. 34 in ( 21.19 cm) IM-FTCC-M Physical Dimensions – Front View IMI-FTCC-M Physical Dimensions – Front View 0.14 in (0.36 cm) 4.49 in (11.41 cm) 0.14 in (0.36 cm) Rests on Table Surface 5.38 in (13.67 cm ) 5.29 in (13.44 cm) 6.88 in (17.
Crestron IM-FTCC-M iMedia FlipTop Computer Center IM-FTCC-M Physical Dimensions – Side View IMI-FTCC-M Physical Dimensions – Side View 4.19 in (10.65 cm) 4.77 in (12.11 cm) Power Cord IM-FTCC-M Front Face View IMI-FTCC-M Front Face View SELECT 1 2 1 3 IM-FTCC-M Bottom View 4 5 2 3 IMI-FTCC-M Bottom View 6 7 8 Operations & Installation Guide – DOC.
iMedia FlipTop Computer Center Crestron IM-FTCC-M Connectors, Controls & Indicators # CONNECTORS, CONTROLS & INDICATORS 1 125VAC 10A (1) 3-prong grounded AC socket, AC power pass-thru outlet; Maximum Load: 10 Amps @ 125 Volts AC, 50/60 Hz. 250V 10A (1) 3-prong grounded AC socket, AC power pass-thru outlet; Specify socket type (refer to “Appendix: International Receptacles” on page 22); Maximum Load: 10 Amps @ 250 Volts AC, 50/60 Hz.
Crestron IM-FTCC-M iMedia FlipTop Computer Center Connectors, Controls & Indicators (Continued) # CONNECTORS, CONTROLS & INDICATORS 7 COMPUTER DESCRIPTION PIN1 PIN6 PIN 15 8 GROUND (1) DB15HD female, RGB(VGA) input; Formats: RGBHV, RGBS, RGsB; Input impedance: 75 Ω; Sync impedance: 1 kΩ; Maximum input level: 1 Vp-p; Maximum sync level: 5 Vp-p; Connects to 6 ft VGA patch cable (included).
iMedia FlipTop Computer Center Crestron IM-FTCC-M Industry Compliance As of the date of manufacture, the IM-FTCC-M has been tested and found to comply with specifications for CE marking and standards per EMC and Radiocommunications Compliance Labelling. NOTE: This device complies with part 15 of the FCC rules.
Crestron IM-FTCC-M iMedia FlipTop Computer Center Setup Network Wiring When wiring the network, consider the following: • Use Crestron Certified Wire. • Use Crestron power supplies for Crestron equipment. • Provide sufficient power to the system. CAUTION: Insufficient power can lead to unpredictable results or damage to the equipment. IM Wiring Using a proprietary signal routing solution, RGBHV, audio, power and control signals are all transported using a single cable solution called iMedia.
iMedia FlipTop Computer Center Crestron IM-FTCC-M Maximum Resolution and Cable Length (Continued) RESOLUTION REFRESH RATE (HZ) PIXEL RATE (MHZ) PIXEL TIME (NS) MAX LENGTH (FEET) 60 75 85 60 70 85 108.00 135.00 157.50 162.00 189.00 229.50 9.3 7.4 6.3 6.2 5.3 4.4 50.9 40.7 34.9 34.0 29.1 24.0 218.5 SXGA (1280 X 1024) UXGA (1600 X 1200) COMPOSITE VIDEO For more information on CresCAT and other wire products, visit the Crestron website (www.crestron.
Crestron IM-FTCC-M iMedia FlipTop Computer Center 2. Thread the cables through the appropriate slots on the plate. 3. Snap the bushings into the plate slots. 4. Feed all the excess cable through the opening. 5. Attach the plate using the four #4-40 x ¼” black screws. 6. Connect the cables to the appropriate connectors on the bottom of the IM-FTCC-M. 7. The cables may be secured to the bottom bar using tie wraps.
iMedia FlipTop Computer Center Crestron IM-FTCC-M Cable Loops Through the Cable Plate (IM-FTCC-M Shown) Allow approximately 40 inches for cable clearence RGB Cable Audio Cable Power Cord NOTE: Ensure that the cables have sufficient clearance to enable smooth movement. Allow approximately 40 inches (102 cm) from the top surface of the FlipTop box mounting to surface. Mounting to Surface The IM-FTCC-M is designed to mount in a horizontal surface, such as a desk top, lectern, or podium.
Crestron IM-FTCC-M iMedia FlipTop Computer Center Cutout Dimensions for IMI-FTCC-M (4007909) 7 13/16 in (198 mm ) 5 1/8 in (131 mm) Radius 1/8 in (4 mm ) NOTE: Before inserting the IM-FTCC-M in the mounting hole, ensure that all required cables have been installed. Mounting Parts Supplied with the IM-FTCC-M PART DESCRIPTION Screw #6-32, Pan Head, Phillips QUANTITY 4 Screw #10-32, Pan Head, Phillips 4 Mounting Bracket 2 1.
iMedia FlipTop Computer Center Crestron IM-FTCC-M 3. Install the four #10-32 screws in the mounting brackets (two screws per bracket). Refer to the following diagram. 4. Slide the mounting brackets over the #6-32 screws and tighten the #6-32 screws. 5. Turn the four #10 screws equally until they contact the underside of the mounting surface. NOTE: Do not over-tighten the #10 screws as this may damage the surface and/or the unit.
Crestron IM-FTCC-M iMedia FlipTop Computer Center Hardware Hookup Make the necessary connections as called out in the illustration that follows this paragraph. Apply power after all connections have been made. When making connections to the IM-FTCC-M, consider the following: • Use Crestron power supplies for Crestron equipment. • The included cable cannot be extended.
iMedia FlipTop Computer Center Crestron IM-FTCC-M NOTE: For optimum performance, Crestron strongly recommends using CresCAT-IM cables, available from Crestron. Other high-quality/low skew CAT5e/CAT6 wiring may also be used with varying performance. NOTE: Ensure that the unit is properly grounded. NOTE: The maximum continuous current from equipment under any external load conditions shall not exceed a current limit that is suitable for the minimum wire gauge used in interconnecting cables.
Crestron IM-FTCC-M iMedia FlipTop Computer Center Operation The IM-FTCC-M can be used to turn a system on or off, adjust volume, or adjust the microphone level. Turn on the System Press the SELECT button to turn on the system with the signals routed to the IM receiver. The associated LED will light. Adjust Volume Turn the volume knob clockwise to raise the volume of the input; turn counterclockwise to lower the volume of the input.
iMedia FlipTop Computer Center Crestron IM-FTCC-M Problem Solving Troubleshooting The following table provides corrective action for possible trouble situations. If further assistance is required, please contact a Crestron customer service representative. IM-FTCC-M Troubleshooting TROUBLE POSSIBLE CAUSE(S) CORRECTIVE ACTION SELECT LED does not illuminate when SELECT button is pressed. Not receiving power. Verify that the iMedia cable is properly attached. No video output displayed.
Crestron IM-FTCC-M iMedia FlipTop Computer Center Further Inquiries If you cannot locate specific information or have questions after reviewing this guide, please take advantage of Crestron's award winning customer service team by calling the Crestron corporate headquarters at 1-888-CRESTRON [1-888-273-7876]. For assistance in your local time zone, refer to the Crestron website (www.crestron.com/offices) for a listing of Crestron worldwide offices.
iMedia FlipTop Computer Center Crestron IM-FTCC-M Appendix: International Receptacles PART NUMBER DESCRIPTION COUNTRIES 6003287 6501271 PWR-AU-B POWER RECEPTACLE, AUSTRALIA, 250V, 10A, BLK Australia, Fiji, New Zealand, Papua New Guinea 6003288 6501272 PWR-EU-B POWER RECEPTACLE, EUROPE "SCHUKO", 250V, 16A, BLK Austria, Azerbaijan, Belarus, Bosnia and Herzegovina, Brunei, Bulgaria, Burundi, Cape Verde, Chad, Croatia, Czech Republic, Egypt, Eritrea, Finland, Georgia, Germany, Greece, Greenland, Guine
Crestron IM-FTCC-M iMedia FlipTop Computer Center Return and Warranty Policies Merchandise Returns / Repair Service 1. No merchandise may be returned for credit, exchange or service without prior authorization from CRESTRON. To obtain warranty service for CRESTRON products, contact an authorized CRESTRON dealer. Only authorized CRESTRON dealers may contact the factory and request an RMA (Return Merchandise Authorization) number.
Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888.CRESTRON Fax: 201.767.7576 www.crestron.com Operations & Installation Guide DOC. 6610A (2018825) 09.07 Specifications subject to change without notice.
