Installation guide

High-Definition Video Scaler Crestron HD-SCALER
26
•
High-Definition Video Scaler: HD-SCALER Operations & Installation Guide – DOC. 7136B
• Overscan: Sets overscan to None (default), 2.5%, 5.0%, or 7.5%.
• Source Control: Sets the video input signal type: Auto, RGB, YPbPr,
S-Video, CVBS, or CVBS (VCR mode). When set to Auto, only RGB and
component video signals are automatically detected.
In addition, the Signal Information menu item provides display of analog input
signal information.
Configuring Digital Input Parameters
To configure digital input parameters, navigate to the Digital Input main menu item
and then press OK on the IR remote.
The Digital Input submenu appears as shown below.
Digital Input Submenu
The Digital Input submenu allows configuration of the following parameters:
• Contrast: Adjusts the contrast level of the video.
• Brightness: Adjusts the brightness level of the video.
• EDID: Specifies whether the digital input EDID is to be set to the default
EDID of the display or copied (cloned) from the output EDID of the
display.
• Overscan: Sets overscan to None (default), 2.5%, 5.0%, or 7.5%.
In addition, the Signal Information menu item provides display of digital input
signal information.