Installation guide

High-Definition Video Scaler Crestron HD-SCALER

•

High-Definition Video Scaler: HD-SCALER Operations & Installation Guide – DOC. 7136B

Setup

Network Wiring

When wiring the Cresnet network, consider the following:

• Use Crestron Certified Wire.

• Use Crestron power supplies for Crestron equipment.

CAUTION: Failure to use Crestron power supplies could cause equipment

damage or void the Crestron warranty.

• Provide sufficient power to the system.

CAUTION: Insufficient power can lead to unpredictable results or damage

to the equipment. Use the Crestron Power Calculator to help calculate how

much power is needed for the system (

www.crestron.com/calculators).

For Cresnet networks with 20 or more devices, use a Cresnet Hub/Repeater

(CNXHUB) to maintain signal quality.

For more details, refer to “Check Network Wiring” on page 28.

Identity Code

NOTE: The latest software can be downloaded at www.crestron.com/software.

The Net ID of the HD-SCALER has been factory set to A3. The Net IDs of multiple

HD-SCALER devices in the same system must be unique. Net IDs are changed from

a personal computer (PC) via Crestron Toolbox™ (refer to “Establishing

Communication” on page 18).

When setting the Net ID, consider the following:

• The Net ID of each unit must match an ID code specified in the Crestron

Studio™ or SIMPL Windows program.

• Each network device must have a unique Net ID.

For more details, refer to the Crestron Toolbox help file.