Installation guide

Crestron HD-SCALER High-Definition Video Scaler

Operations & Installation Guide – DOC. 7136B High-Definition Video Scaler: HD-SCALER

•

Connectors, Controls, and Indicators (Continued)

# CONNECTOR6

1

NTROLS, AND

INDICATORS

DESCRIPTION

11 IR IN (1) IR receiver window for use with

remote provided

12 HDMI OUT LED (1) Green LED, indicates output signal

presence

13 HDMI IN LED (1) Green LED, indicates HDMI input is

selected

14 RGB IN LED (1) Green LED, indicates RGB input is

selected

15 PWR LED (1) Green LED, indicates 24 Vdc power

supplied via Cresnet network or local

power pack

1. Interface connector for the NET port is provided with the unit.

2. The RGBHV input can accept component, composite, and S-video signals via direct interface to

Crestron MPS Series products or through an appropriate adapter (not included). Composite and

S-video signals are not detected automatically and must be selected programmatically or manually.

Refer to the following table for the RGBHV IN connector pinouts.

RGBHV IN Connector Pinouts

PIN 1 PIN 5

PIN 10

PIN 6

PIN 11

PIN 15

PIN # RGB YPbPr S-VIDEO COMPOSITE

1 R Pr C

2 G Y Y

3 B Pb Comp

5 Gnd Gnd Gnd Gnd

6 Red_Gnd Pr_Gnd C_Gnd

7 Grn_Gnd Y_Gnd Y_Gnd

8 Blu_Gnd Pb_Gnd

13 H

14 V

For best video performance, grounds should be kept separate. Grounds should not be connected to the

connector shell. The connector shell is reserved for the cable shield.

3. HDMI IN requires an appropriate adapter or interface cable to accommodate a DVI or DisplayPort

multimode signal. HDMI OUT requires an appropriate adapter or interface cable to accommodate a

DVI signal. CBL-HD-DVI interface cables sold separately.