Installation guide

QuickSwitch HD HDMI Switcher Crestron HD-MD8X1/HD-MD8X2
10  QuickSwitch HD HDMI Switcher: HD-MD8X1/HD-MD8X2 Operations & Installation Guide – DOC. 6714B
Connectors, Controls, and Indicators
#
CONNECTORS
1
,
CONTROLS, AND
INDICATORS
DESCRIPTION
1 PWR LED
(1) Green LED, indicates 24 Vdc power
supplied from Cresnet control network
2 NET LED
(1) Amber LED, indicates communication with
Cresnet system
3
SYNC
(Button and LED)
(1) Recessed push button and red LED,
selects Sync mode for viewing input signal
sensing
4
VIEW
(Button and LED)
(1) Push button and red LED, selects View
mode for viewing current routes
5
ROUTE
(Button and LED)
(1) Push button and red LED, selects Route
mode to allow routing changes
6
A
(Button and LED)
(1) Push button and red LED, selects audio
routing view
7
V
(Button and LED)
(1) Push button and red LED, selects video
routing view
8
IN 1-8
(Buttons and LEDs)
(8) Push buttons and red LEDs, select input
for routing
9
OUT 1/OUT 1-2
(Buttons and LEDs)
HD-MD8X1 (1) or HD-MD8X2 (2) push
buttons and red LEDs, select output for
routing
10
INPUT 1-8 (8) 19-pin Type A HDMI female;
HDMI digital video/audio inputs;
Supports DVI and DisplayPort Multimode
2
11
OUTPUT 1/
OUTPUT 1-2
HD-MD8X1 (1) or HD-MD8X2 (2) 19-pin
Type A HDMI female;
HDMI digital video/audio outputs;
Supports DVI
2
12
LAN
Green
LED
Amber
LED
Pin 8
Pin 1
(1) 8-pin RJ-45 with two LED indicators;
10BASE-T/100BASE-TX Ethernet port,
Green LED indicates link status;
Amber LED indicates Ethernet activity
PIN SIGNAL PIN SIGNAL
1 TX + 5 N/C
2 TX - 6 RC -
3 RC + 7 N/C
4 N/C 8 N/C
13
COMPUTER (1) USB Type B female;
USB 2.0 computer console port
(6 ft cable included)
14
SETUP
(Button and LED)
(1) Miniature push button and red LED, used
for touch-settable ID (TSID) and Ethernet
autodiscovery
(Continued on following page)