Specifications

Quad 1-to-2 HDMI™ Distribution Amplifier Crestron HD-DA-2-QUAD
Ear Attachment for Rack Mounting (this image shows a 1RU device)
USE COVER SCREWS
4. Repeat procedure (steps 1 through 3) to attach the remaining ear to the
opposite side.
Stacking
Four “feet” are provided with the HD-DA-2-QUAD so that if the unit is not rack
mounted, the rubber feet can provide stability when the unit is placed on a flat
surface or stacked. These feet should be attached prior to the hookup procedure.
NOTE: No more than two HD-DA-2-QUAD units should be stacked.
Hardware Hookup
Make the necessary connections as called out in the illustration that follows this
paragraph. Apply power after all connections have been made.
When making connections to the HD-DA-2-QUAD, note the following:
• The HD-DA-2-QUAD may be powered by the included 24V DC power
pack or Cresnet network power, not both.
• The CEC signal is only carried on ports that are connected to display
devices.
Hardware Connections for the HD-DA-2-QUAD
IN 1:
From HDMI
Source
OUT 1:
To Loop-Thru Device
OUT 2:
To Display
Device
OUT 1:
To Display
Device
IN 2:
From HDMI
Source
OUT 2:
To Loop-Thru
Device
IN 3:
From HDMI
Source
OUT 3:
To Loop-Thru Device
OUT 3:
To Display
Device
OUT 4:
To Display
Device
IN 4:
From HDMI
Source
OUT 4:
To Loop-Thru
Device
COMPUTER:
To USB Port on
PC
PWR:
From Crestron
24VDC Power Supply
24VDC 1.0A:
From Included Power
Supply
GROUND:
Tie All Source Grounds to
Ground Terminal
NOTE: Ensure the unit is properly grounded by connecting the chassis ground lug
to an earth ground (building steel).
8 • Quad 1-to-2 HDMI™ Distribution Amplifier: HD-DA-2-QUAD Operations Guide – DOC. 6713B