Setup guide

Crestron IPAC-GL1 Integrated Professional Automation Computer

Ethernet Setup

The IPAC can be configured to use a static IP address (DHCP is off) or to obtain an

IP address from a DHCP server (DHCP is on). To configure the IPAC:

1. From the home page, press the soft button labeled Setup.

2. Turn the selection knob to highlight Ethernet Settings.

3. Press ENTER or the soft button labeled Select to open the Ethernet

Settings section of the Setup Menu. The current DHCP setting will be

displayed.

Select DHCP Mode

Ethernet – DHCP

DHCP: [Off]

4. Turn the selection knob to the desired setting and press the soft button

labeled Done (if enabling DHCP) or Next (if disabling DHCP).

If Done is pressed, the IPAC will prompt to be rebooted. Press the soft

button labeled Yes to reboot or press the soft button labeled No to return to

the DHCP mode display. To view the Ethernet settings after enabling

DHCP, open the About section as described on page 51.

5. If DHCP mode is disabled, the IPAC’s Ethernet settings will be displayed.

Ethernet Settings

IP Addr: 172.030.161.025

Mask: 255.255.241.000

Router: 172.030.160.002

Edit Done

Setup Guide – DOC. 6660B Integrated Professional Automation Computer: IPAC-GL1 • 49