Setup guide

Crestron IPAC-GL1 Integrated Professional Automation Computer
Password
The IPAC can be configured to use password protection to unlock the front panel or
open the Setup menu.
Open Password
To open the Password section of the Setup Menu:
1. From the home page, press the soft button labeled Setup.
2. Turn the selection knob to highlight Password.
3. Press ENTER or the soft button labeled Select to open the Password
section of the Setup Menu. If a password has been set, enter the password
as described on page 48.
Create/Edit Password
If a password has not been assigned, a password (eight-character maximum, letters
only) can be assigned to lock the front panel of the IPAC.
If a password has already been set, the password can be edited.
To set/edit a password:
1. Open the Password section of the Setup Menu as described above.
Create a Password
Password Setup
Clear Done
[ ]
2. Turn the selection knob until the first desired letter of the password is
displayed.
3. Press ENTER to move the cursor to the next letter of the password.
To move the cursor to the beginning of the password, press ENTER until
the cursor is at the beginning of the password.
4. Turn the selection knob to display the next letter of the password.
5. Repeat steps 3 and 4 until the desired password is displayed.
To erase the displayed entry, press the soft button labeled Clear.
6. Press the soft button labeled Done.
If the password is left blank, pressing the soft button labeled Done will
remove password protection
Setup Guide – DOC. 6660B Integrated Professional Automation Computer: IPAC-GL1 • 47