Setup guide

Integrated Professional Automation Computer Crestron IPAC-GL1
⇒ To assign a function:
Loads can be set to turn off upon sensor input or toggle their state
(on/off). To select a mode, turn the selection knob to highlight a load
and press the soft button labeled Mode to toggle between the available
modes (Off Only or On/Off).
When a sensor becomes active, all loads assigned to this sensor and set
to On/Off shall turn on. When the sensor becomes inactive, all loads
assigned to this sensor shall turn off.
Assign a Sensor
Mode Edit OK
Sensor Load Assignment
L1.1 = Int (On/Off)
L1.2 = C0.1 (Off Only)
L1.3 = ---
SelectEdit
3. When you are finished assigning sensors and functions to loads, press the
soft button labeled OK to return to the Sensors section of the Setup Menu.
4. To exit the Sensor section of the Setup Menu and save any changes, press
the soft button labeled Exit. Otherwise, press CANCEL.
Copy/Paste Sensor
Assignments
A load’s sensor assignment and function can be copied to another load using the soft
buttons labeled Copy and Paste.
• To copy a load’s sensor assignment and functionality:
1. Open the Sensors section of the Setup Menu as described on page 39.
2. Press the soft button labeled Loads or press ENTER.
3. Turn the selection knob to highlight the load containing the sensor
assignment and functionality to be copied and press the soft button
labeled Copy. The load’s sensor assignment and functionality are now
in memory and is ready to be pasted.
• To paste a load’s sensor assignment and functionality:
1. Open the Sensors section of the Setup Menu as described on page 39.
2. Press the soft button labeled Loads or press ENTER.
3. Turn the selection knob to highlight the load to contain the copied
sensor assignment and functionality and press the soft button labeled
Paste.
• To cancel the copy/paste operations and return to the list of sensor load
assignments, press the soft button labeled Cancel.
46 • Integrated Professional Automation Computer: IPAC-GL1 Setup Guide – DOC. 6660B