Setup guide

Crestron IPAC-GL1 Integrated Professional Automation Computer
• Start of Workday
Using the “Start of Workday” parameter will cause lights that are
turned on before the “Start of Workday” time to automatically turn off
after one hour with a flashing warning as specified on page 27. To set
the time when a workday starts:
1. Turn the selection knob to highlight Start of Workday and press
the soft button labeled Edit. Brackets will appear around the hour
digit.
Set Start of Workday Time
Next
Timeclock Event - Time
[06] : 00 AM
SelectNext
2. Turn the selection knob to display the desired hour.
3. Press the ENTER button to move the cursor between the hour,
minute, and AM/PM.
4. Use the selection knob and the ENTER button to display the “Start
of Day” time.
5. When the correct time is displayed, press the soft button labeled
Next to set the “Start of Workday” time.
• End of Workday
Using the “End of Workday” parameter will cause lights that are turned
on after the “End of Workday” time to automatically turn off after one
hour with a flashing warning as specified on page 27.
NOTE: If a light is on when the time passes the “End of Workday”
time, the light will turn off one hour after the “End of Workday” time.
For example, if the “End of Workday” time is 8:00 PM and a light is on
at 8:00 PM, the lights will turn off at 9:00 PM.
NOTE: Lights that are turned on from a keypad or the IPAC front
panel after the “End of Workday” time will turn off automatically.
Lights that are turned on by sensor/timeclock events will not turn off
automatically.
Setup Guide – DOC. 6660B Integrated Professional Automation Computer: IPAC-GL1 • 29