Setup guide

Crestron IPAC-GL1 Integrated Professional Automation Computer
4. Turn the selection knob to highlight Find by entering S/N and press
the soft button labeled Next. The display will show a serial number
with the first digit enclosed in brackets.
Enter Serial Number
OK
Keypad – Enter S/N
[1]234567
5. Turn the selection knob clockwise or counter-clockwise to display the
first digit of the serial number. When the correct value (letter or
number) is displayed, press the ENTER button to move the brackets to
the next digit.
6. Repeat for each digit in the serial number. When the correct serial
number is displayed, press the soft button labeled OK.
If the correct serial number is entered, the display will indicate that the
keypad was found and then show programming information for the
identified keypad. For information on keypad programming, refer to
“Program/Edit a Keypad Button Manually” on page 20.
If the incorrect serial number is entered, a message will be displayed as
shown in the following diagram.
Unable to Set ID
Menu Retry
Keypad – Enter S/N
[1]234567
Unable to set ID.
Return to the
Keypad Menu?
Press the soft button labeled Retry to re-enter the serial number or
press the soft button labeled Menu to return to the list of keypads.
Repeat for each external keypad in the system.
Automatically Program a
Button
Any keypad button in the IPAC system (front panel keypad or identified external
keypad) can be quickly programmed using the soft button labeled Auto. To
automatically program a button:
1. Open the Keypads section of the Setup Menu as described on page 15.
Setup Guide – DOC. 6660B Integrated Professional Automation Computer: IPAC-GL1 • 17