Setup guide

Integrated Professional Automation Computer Crestron IPAC-GL1

3. Press the soft button labeled Find to begin the identification process.

Select Identification Method

Keypad – Set ID

Find by pressing button

Find by entering S/N

SelectNext

4. Turn the selection knob to highlight Find by pressing button and

press the soft button labeled Next.

5. Every connected keypad will flash. The display will prompt you to

press a button on the keypad to be identified.

NOTE: If a keypad does not flash, verify that it is properly connected

to the network. Refer to “Check Network Wiring” on page 53 for more

information.

6. Press a button on the keypad to be identified. The display will show

programming information for the identified keypad. For information

on keypad programming, refer to “Program/Edit a Keypad Button

Manually” on page 20.

• By Serial Number:

1. Open the Keypads section of the Setup Menu as described on page 15.