Setup guide

Integrated Professional Automation Computer Crestron IPAC-GL1
14 • Integrated Professional Automation Computer: IPAC-GL1 Setup Guide – DOC. 6660B
The IPAC will show a graphic which represents a panel and four modules
installed within it, ranging from top to bottom. Note that many panels will
have less than four modules installed, but none will have more than four.
Inside the boxes representing the modules will be 2-digit ID codes. These
indicate the Module ID that each module must be set to in order to work
properly.
Next to each module in the display is a label: OK (a module at this ID has
been found on the network), ERR (no module at this ID has been found), or
--- (this panel already has enough modules defined to satisfy the load
count).
4. Set the Module ID of each module in a panel to the number specified on the
display. For information on setting Module IDs, refer to the latest version of
the CRESTRON GREEN LIGHT™ Power Switching Installation Guide
(Doc. 6672) which was shipped with the panel, and is available for
download from the Crestron website.
NOTE: Care must be taken to ensure that no two modules in the system
share the same Module ID. This situation will cause unpredictable behavior.
Additionally, a module with a Module ID outside of the specified value
may conflict with other devices in the system.
After the Module ID is set correctly, the module label will change from
ERR to OK.
5. After all of the modules in a panel have been identified, press the soft
button labeled OK or press the ENTER button to return to the panel list.
6. Repeat the identification process for each panel in the system.
7. After all of the panels have been configured and identified, press the soft
button labeled EXIT to save the settings and return to the Setup Menu.