Setup guide

Crestron IPAC-GL1 Integrated Professional Automation Computer

2. Turn the selection knob to the desired panel and press the ENTER button or

the soft button labeled Edit.

Set the Number of Loads

Set

1: [24] Loads

2: --- ---

3: --- ---

4: --- ---

Load

Count

SelectSet

3. Turn the selection knob until the desired load count is displayed.

4. Press the ENTER button or the soft button labeled Set.

5. Repeat for every panel in the system.

Clear a Panel

To remove a panel from the system:

1. Open the Panels section of the Setup Menu as described on page 12.

2. Turn the selection knob to highlight the panel to be cleared and press the

soft button labeled Clear. Alternately, you can manually adjust the load

count of a panel to 0 (zero). This will have the same effect as pressing

Clear.

NOTE: If only one panel is listed, it cannot be cleared.

Identify Modules

Each load in a panel is switched on and off by a lighting module installed in the

panel. To properly control the loads in a system, the modules to which they are

connected must be identified to the IPAC. To identify modules:

1. Open the Panels section of the Setup Menu as described on page 12.

2. Turn the selection knob to highlight the panel to be identified.

3. Press the soft button labeled ID.

Identify Modules

ERR

---

Set Module ID’s

in PNL-2 to these

values:

SelectOK

Setup Guide – DOC. 6660B Integrated Professional Automation Computer: IPAC-GL1 • 13