Specifications

4
quickstart guide
GL-IPAC-SW8
www.crestron.com
888.273.7876 201.767.3400
Specifications subject to
change without notice.
GL-IPAC-SW8
Crestron Green Light
®
Integrated Switching System
For Regulatory Compliance information, refer to Doc. 7401.
QUICKSTART DOC. 7389B (2036222, Sheet 2 of 7) 01.14
Adding an Additional Lighting Panel
Adding an additional lighting panel to the GL-IPAC-SW8 is accomplished
by connecting the two panels together via the Cresnet port.
GLEX-FT-* Panel
Cresnet
Cable
24 Y Z G
CRESNET
24 Y Z G
CRESNET
Photocell Wired to SENSORS 5-8 Port
Photocells can only be wired to the right SENSORS 5-8 port.
Photocell
(GLS-LOL)
SENSORS 5-8
24 1 2 3 4 G 24 1 2 3 4 G
SENSORS 1-4
Photocell Wired Using Cresnet to GLS-SIM
GLS-SIM
Photocell
(GLS-LOL)
Cresnet
Cable
24 Y Z G
CRESNET
24 Y Z G
NET
24 1 2 G
SENSOR
Adding Additional Power
Power Supply
From 120/277 V
Power Source
To Cresnet
Device(s)
24 Y Z G
CRESNET
Do not connect
external power
supply to 24 from
GL-IPAC-SW8
Using GLS-PLS-120/277 to Provide Override Control
A GLS-PLS-120/277 connects to 3-phase inputs and neutral
power connections. The OUTPUT 1 or OUTPUT 2 port connects
to the OVERRIDE OR G port on the GL-IPAC-SW8.
OR G
OVERRIDE
Line 1
Line 2
Line 3
Neutral
GL-IPAC-SW8
INPUT
CHANNEL
DIP
SWITCH
SETTING
1
1 -
2 -
2
3 On
4 Off
Use the dials to set the ID of the GLS-SIM to C0 - C9 to match the
ID defined in the program.
NOTE: A maximum of 10 GLS-SIMs may be connected.
Wiring Diagram (Continued)