Installation guide

Power Switching Cabinet GLPX-SW-FT Crestron Green Light Express

18 • Crestron Green Light Express

Power Switching Cabinet GLPX-SW-FT Installation Guide – DOC. 6886B

Testing

Manual Control

Lighting loads can be manually controlled from the front panel.

NOTE: To disable local control, press the ENABLE button again or wait for two minutes. The red LED beside the

button deactivates.

NOTE: The control system program may change the settings if the Override mode is not enabled.

Override Mode

The Override mode overrides the control system program and sets all of the output states to the stored override

values. For instructions on saving override settings, refer to “Save Override Settings” below.

To enable Override mode, press and release the OVR button. The OVR LED flashes slowly.

NOTE: If the Override mode was enabled from an external device (i.e. a contact closure is present on the OVR

terminals), the OVR LED flashes quickly. Pressing the OVR button has no effect.

To disable Override mode, press the OVR button again. The OVR LED extinguishes and the outputs return to the

states set by the control system program.

NOTE: If override states have not been stored, the factory default override state is all loads on.

Save Override Settings

The state of each output can be saved as an override setting, which can be automatically recalled when the Override

mode is enabled.

NOTE: The control system program has a setting that can prevent locally saving the override state. If this setting is

enabled, the display shows “Er” when trying to save override states. For more information, refer to the SIMPL

Windows help file.

To save the state of an output as an override setting, press and hold the OVR button for three seconds. The OVR

LED blinks to indicate the new override setting has been stored.

System Operation and Commissioning

This cabinet has been designed as a component of a programmed Crestron system. Refer to “Appendix C: Setting

Module Net IDs” on page 24

for information on system setup. System commissioning by an authorized Crestron

representative must

be performed to ensure system operation.

Once the cabinet has been wired and the modules have been tested, contact Crestron at 1-888-CRESTRON

[1-888-273-7876] to schedule commissioning.