Installation guide

Crestron Green Light Express
®
Power Switching Cabinet GLPX-SW-FT
Installation Guide – DOC. 6886B Crestron Green Light Express
®
Power Switching Cabinet GLPX-SW-FT • 17
NET Port Wiring
When wiring the supplied NET connectors for connection to a Crestron control system or other device on the
Cresnet network, use Crestron certified wire such as CRESNET-NP or CRESNET-P. For instructions on
network wiring, refer to “Appendix B: Network Wiring” on page 21.
When daisy-chaining connections between NET ports, strip the ends of the wires carefully to avoid nicking the
conductors. Twist together the ends of the wires that share a pin on the network connector, insert the connection
into the Cresnet connector, tighten the retaining screw. Repeat the procedure for the other three conductors.
OVR (Override) Port Wiring
When a connection is applied between the OVR (override) terminals, the modules enter Override mode. The
Crestron GLS-PLS-120/277 phase-loss sensor or any device that provides a dry contact closure can be
connected to the supplied OVR connector on the bottom of the cabinet.