Installation guide

Power Switching Cabinet GLPS-HDSW-FT CRESTRON GREEN LIGHT
®
EXPRESS
NET Port Wiring
When wiring the supplied NET connectors for connection to a Crestron control system or other device on the
Cresnet network, use Crestron certified wire such as CRESNET-NP or CRESNET-P. For instructions on
network wiring, refer to “Appendix C: Network Wiring” on page 18.
When daisy-chaining connections between NET ports, strip the ends of the wires carefully to avoid nicking the
conductors. Twist together the ends of the wires that share a pin on the network connector, insert the connection
into the Cresnet connector, tighten the retaining screw. Repeat the procedure for the other three conductors.
OVERRIDE Port Wiring
When a connection is applied between the override terminals, the modules will enter Override mode. The
Crestron GLS-PLS-120/277 phase-loss sensor or any device that provides a dry contact closure can be
connected to the supplied OVERRIDE connector on the bottom of the cabinet.
Mechanical Override
1. Locate the mechanical override rocker switch labeled STATUS on the top of the relay.
Mechanical Override Switch
MECHANICAL
OVERRIDE
2. Place the tip of a screwdriver on the switch and push against the indentation.
3. The rocker switch will toggle into either an “ON or OFF” position, overriding the current state.
10 • GREEN LIGHT
®
EXPRESS Power Switching Cabinet GLPS-HDSW-FT Installation Guide – DOC. 6887A