Installation guide

Crestron DIN-IO8 DIN Rail Versiport Module
Hardware Hookup
Connect the
Device
Make the necessary connections as called out in the illustration that
follows this paragraph. Refer to “
Network Wiring” on page 10 before
attaching the 4-position terminal block connector. Apply power after all
connections have been made.
WARNING: Prior to connecting the device, turn off power at the circuit
breaker. Failure to do so may result in serious personal injury or damage
to the device. Restore power after all connections have been made.
CAUTION: Connecting this device to the wrong type of load, or short-
circuiting the load can cause severe product damage. Each load should be
tested to identify a short circuit condition prior to wiring the load to the
module.
NOTE: Install in accordance with all local and national electric codes.
NOTE: Use copper wire only.
When making network connections to the DIN-IO8, use a Crestron
power supply.
Operations & Installation Guide – DOC. 6664A DIN Rail Versiport Module: DIN-IO8 • 13