Installation guide

DIN Rail Versiport Module Crestron DIN-IO8
The DIN-IO8 is designed for installation on a DIN rail. Refer to the
following diagram when installing.
Installing the DIN-IO8
DIN RAIL RELEASE
TOP
DIN RAIL
(NOT SUPPLIED)
DIN-IO8
1. Place the top of the DIN-IO8’s rail mount over the top of the DIN
rail.
2. Tilt the bottom of the DIN-IO8 toward the DIN rail until it snaps
into place.
NOTE: When mounting DIN rail products, it may be necessary to
use a flat-head screw driver to pull the DIN rail release tab while
snapping the device onto the DIN rail.
To remove the DIN-IO8 from the DIN rail, use a small, flat object (i.e. a
flat-head screwdriver) to pull the DIN rail release tab and tilt the bottom
of the DIN-IO8 away from the DIN rail.
NOTE: Certain third party DIN cabinets provide space for an
informational label between each DIN rail row. Crestron’s Engraver
software (version 4.0 or later) can generate appropriate labels for all
Crestron DIN rail products.
12 • DIN Rail Versiport Module: DIN-IO8 Operations & Installation Guide – DOC. 6664A