Specifications

Crestron Commercial Lighting Design Guide
Doc. 4775B | Crestron.com 15
Module Specifications
GLX-DIM6
The GLX-DIM6 is a Crestron Green Light architectural dimming module which features 6 channels of
incandescent, magnetic low-voltage, and 2- and 3-wire fluorescent dimming. The module is part of a complete
Crestron engineered GLPD Green Light architectural dimming panel.
• 6 channels of incandescent, MLV, 2- & 3-wire fluorescent dimming
• Phase-Synchronous detection eliminates lamp flicker
• Selectable non-dim mode
• Supports 100 to 277 Volt applications
• 16 amp load rating per channel
• Short circuit and overload protection
• Positive air gap at each output
• Phase-independent channels
• Cresnet communications
• Redundant power capability—module powered via line or Cresnet
• Local controls for testing and verification
• Local and remote override capability
• Non-volatile power failure memory
Load Ratings
Switch Channels
6
Per Channel
16 amps at 100-277 Vac, 50/60 Hz
Dim Load Types Incandescent, Magnetic Low-Voltage, Neon/Cold Cathode, 2-
wire Fluorescent
Ballast, or 3-wire Fluorescent Ballast
Switch Load Types Incandescent, Magnetic Low-Voltage, Electronic Low-Voltage, Neon/Cold Cathode,
Fluorescent Ballast, High-Intensity Discharge
Power Requirements
Primary
100-277 Vac, 50/60Hz, supplied via channel 1 (L1, N1)
Secondary (optional)
9 watts at 24 Vdc, supplied via Cresnet
Environmental
Temperature
32° to 104°F (0° to 40°C)
Humidity
10% to 90% RH (non-condensing)
Heat Dissipation
550 BTU/Hr
Electrical Regulatory Certifications
UL508, Section 41 (Endurance Test) and Section 61C (Electronic Ballasts)
UL924, Emergency Power Equipment
IEC60669-2-
1, Section 19.102 (Contact mechanisms incorporated in electronic switches, intended for
fluorescent lamp circuits or other capacitive loads)
Module SCCR Rating - 65kA
CE