Installation guide

Crestron FTI-PWR-D FlipTop Power Center - International Version
Mounting Parts Supplied
DESCRIPTION PART
NUMBER
QUANTITY
Screws, #06-32 x 3/16” (~5 mm),
Pan Head, Phillips
2007204 8
Screws, #10-32 x 2” (~51 mm),
Pan Head, Phillips
2007293 4
Mounting Bracket 2013224 2
1. Install the eight supplied #06-32 x 3/16” (~5 mm) screws (2007204) on the
front and back of the unit. Do not fully tighten the screws. These will be
used to secure the front and back mounting brackets. Refer to the
illustration below.
2. Position the FTI-PWR-D in the mounting hole.
Mounting Bracket Screw Locations
3. Thread a small portion of the #10-32 x 2” (~51 mm) screws (2007293) into
the mounting brackets (two screws per bracket). Refer to the illustration on
the following page.
4. Slide the mounting brackets over the #06-32 screws and tighten the
#06-32 screws.
Operations & Installation Guide – DOC. 6797B FlipTop Power Center – International Version: FTI-PWR-D • 9