Specifications

Crestron e-Control
®
Software
SSL Console Commands
For security, all SSL commands are only allowed from a serial connection to the
console.
SSL [OFF | SELF | CA]
'OFF' turns off SSL,
'SELF' sets SSL to use 'self-signed' certificates,
'CA' sets SSL to use 'CA' issued certificates,
No parameter - displays current setting
This command turns the SSL mode on or off. For example, when SSL is on, typing
“SSL” displays the current settings as follows: >SSL: ON,CA. This indicates that SSL
is turned ON and set to read the CA generated certificate.
When SSL is off, typing SSL displays the current settings as follows:
SSL: OFF,CA
This is interpreted as “SSL is OFF and the previous setting was
set to read
CA generated certificate”.
CREATECSR CN:SN:LN:ON:OUN:SN:EA:
CN = 2 letter country code
SN = Full state or province name
LN = Locality or city name
ON = Organization or company name
OUN= Organizational Unit name or division
SN = site name or domain name
EA = Email address
This command creates a CSR. For example, when CREATECSR is run without any
parameters, a default CSR will be created.
XLOADCERTFILE size date time name
size - size of the file in bytes
date - date of the file (MM-DD-YY)
time - time of the file (HH:MM:SS)
name - name of the file
This command loads a certificate file onto the processor. The command works exactly
like the XPUTFILE command, only the “name” parameter should be set to
“srv_cert.der”. The “size”, “date” and “time” parameters should be determined from
the certificate file stored in the host system after obtaining it from a CA. The stored
certificate file in the host is the format *.CER, which is an ASCII file. The command
will convert the file to “\\sys\srv_cert.der
”.
Reference Guide – DOC. 6052 Crestron e-Control® • 61