Specifications

Crestron e-Control

Software

Other configurations are possible. In the setup shown below, the gateway is the

“hardware” gateway that is built into the Ethernet card on the control system. Here

each ActiveCNX control calls the Connect( ) method to start a TCP/IP connection to

the control system. The e-Control gateway receives the packets and performs the

translation to CIP.

PC (192.168.1.3)

ActiveCNX Control -- Connect (IP Address 192.168.1.7, IP ID 05)

192.168.1.XXX Ethernet Network

Control System/Gateway (192.168.1.7)

ActiveCNX Interface (IP Address: 127.0.0.1 IP ID 05)

ActiveCNX Interface (IP Address: 127.0.0.1 IP ID 08)

PC (192.168.1.9)

ActiveCNX Control -- Connect (IP Address 192.168.1.7, IP ID 08)

TCP/IP

CIP

TCP/IP

Controlled Devices

Reference Guide – DOC. 6052 Crestron e-Control® • 43