Specifications

Crestron e-Control
®
Software
gateway is being used. With the CNX-EGWY, the IP address should be the
static IP address of the PC where the gateway resides. (The “Use Hostname”
option does not apply.)
The ActiveCNX Interface and e-Control PC Interface are described in detail
in the section titled “Interfaces to e-Control”.
6. For Ethernet Intersystem Communications: The configuration settings for
the Ethernet ISC symbol depend on the target control system.
• If the target is enabled for DHCP, then click Use Hostname and
enter the fully-qualified domain name of the destination control
system.
• If the target is not enabled for DHCP, then click Use IP Address and
enter the static IP address of the destination control system.
The Ethernet ISC symbol cannot be used for intersystem communication
between an X-Series control system and a DHCP-enabled 2-Series control
system.
The Ethernet ISC symbol is described in detail in the section titled
“Interfaces to e-Control”.
7. With X-Series control systems, the Device Settings dialog box provides a
drop-down list for selecting the IP ID, and a text field for entering the static
IP address of the controlled device. There is no hostname option.
8. When you upload the completed SIMPL Windows logic program, click Yes
when prompted to "Send the Default IP Table to the Control System."
The second method for creating the IP Table enables you to set or change the IP
information and send it to the control system without need to re-compile or re-transfer
the SIMPL Windows program.
1. Open the Crestron Viewport and select Setup IP Table on the Functions
menu.
2. In IP Operations, click Add to add the new IP table entry.
3. Select the hexadecimal IP ID of the device from the IP ID list.
4. In the IP Address/Hostname field, enter the static IP address of the Ethernet
device, or if the device is DHCP-enabled, its fully-qualified domain name.
Reference Guide – DOC. 6052 Crestron e-Control® • 27