Installation guide

Crestron DM-TX-200-2G/400-3G Wall Plate DigitalMedia™ CAT Transmitters
Connectors, Controls & Indicators
# CONNECTORS,
CONTROLS &
INDICATORS
DESCRIPTION
1 PWR LED
(1) Green LED, indicates operating power
supplied via DMNet
2 RESET
(1) Miniature recessed push button for
hardware reset
3 HDMI LED
(1) Green LED, indicates HDMI input is
selected
4 HDMI IN
(1) 19-pin Type A HDMI female;
HDMI digital video/audio input;
Also supports DVI and DisplayPort
Multimode
1
5 AUDIO IN
(1) 3.5 mm TRS mini phone jack;
Unbalanced stereo line-level audio input;
Input Impedance: 10k Ω;
Input Level: 2 V
rms
maximum
6
SETUP
(LED and BUTTON)
(1) Red LED and (1) miniature recessed
push button for Ethernet auto-discovery
7 USB HID
(1) USB Type A female;
USB 1.1 host port for connection of a
mouse/keyboard or other USB HID-compliant
device
8 DM LINK LED
(1) Green LED, indicates connection to a
downstream DM device
9 PC IN
(1) DB15HD female, RGB (VGA) or
component (YP
b
P
r
) video input
2
;
Formats: RGBHV, RGBS, RG
s
B, YP
b
P
r
;
Input Levels: 0.5 to 1.5 V
p-p
with built-in DC
restoration;
Input Impedance: 75 Ω;
Sync Input Type: Autodetect RGBHV, RGBS,
RG
s
B, YP
b
P
r
;
Sync Input Level: 3 to 5 V
p-p
;
Sync Input Impedance: 1k Ω
10 PC LED
(1) Green LED, indicates PC input is
selected
11 GROUNDING WIRE (1) Flying lead, chassis ground connection
3
12 G B A 24
4
(1) DMNet port composed of (4) captive
screw terminals;
Connects to DMNet port of a DM switcher,
receiver/room controller, or other DM device
via DM-CBL cable
5, 6
(Continued on following page)
Operations & Installation Guide – DOC. 6949B Wall Plate DigitalMedia™ CAT Transmitters: DM-TX-200-2G/400-3G • 13