Installation guide

Crestron DM-TX-200 DigitalMedia™ CAT Transmitter 200
Hardware Hookup
Make the necessary connections as called out in the illustration that follows this
paragraph. Refer to “Network Wiring” on page 13 before attaching the 4-position
terminal block connector. Apply power after all connections have been made.
When making connections to the DM-TX-200, note the following:
• Use Crestron power supplies for Crestron equipment.
• The included cable cannot be extended.
Hardware Connections for the DM-TX-200 (Top View) Hardware Connections for the DM-TX-200 (Bottom View)
AUDIO:
Unbalanced Stereo
Line Level Input
HDMI:
Digital Video/
Audio Input
USB HID:
From Mouse/Keyboard
or Game Controller Input
RGB:
RGB or Component
Video Input
DM OUT:
To DM Switcher, Revceiver
or Other DM Device
Ground
G B A 24:
To DMNet Port of Switcher,
Receiver or Other DM Device
NOTE: Ensure the unit is properly grounded by connecting the chassis ground lug
to an earth ground (building steel).
NOTE: To prevent overheating, do not operate this product in an area that exceeds
the environmental temperature range listed in the table of specifications.
NOTE: For optimum performance, Crestron strongly recommends using DM-CBL
DigitalMedia cable, available from Crestron.
NOTE: Minimum recommended length for DM-CBL DigitalMedia cable is 15 feet
(~4.6 meters).
NOTE: When used without a DM switcher, the DM-TX-200 can be powered by a
PW-2407-RU or any Crestron 24 Volt power supply. Power supply not included.
Operations & Installation Guide – DOC. 6741C DigitalMedia™ CAT Transmitter 200: DM-TX-200 • 15