Installation guide

Crestron DM-TX-200 DigitalMedia™ CAT Transmitter 200
Setup
Network Wiring
When wiring the DM network, consider the following:
NOTE: DMNet wiring and Cresnet
®
wiring are not compatible.
• Use Crestron Certified Wire.
• Use Crestron power supplies for Crestron equipment.
• Provide sufficient power to the system.
• For DigitalMedia CAT wiring, use DM-CBL DigitalMedia Cable. Up to
two DM Repeaters (model DM-DR, sold separately) may be required. Refer
to the latest revision of the Crestron DigitalMedia Design Guide (Doc.
4789) for complete wiring guidelines.
CAUTION: Insufficient power can lead to unpredictable results or damage
to the equipment. Please use the Crestron Power Calculator to help calculate
how much power is needed for the system (www.crestron.com/calculators
).
For more details, refer to “Check Network Wiring” which starts on page 22.
Identity Code
NOTE: In the SIMPL™ Windows program, when the DM-TX-200 is dropped onto
an input card of a DM switcher, its IP ID is assigned automatically and does not
require additional programming or configuration. Use the information below when
the DM-TX-200 is dropped directly into an Ethernet slot on the control system in
SIMPL Windows, without a DM switcher.
The IP ID is set within the DM-TX-200’s table using Crestron Toolbox. For
information on setting an IP table, refer to the Crestron Toolbox help file. The IP IDs
of multiple DM-TX-200 devices in the same system must be unique.
When setting the IP ID, consider the following:
• The IP ID of each unit must match an IP ID specified in the SIMPL
Windows program.
• Each device using IP to communicate with a control system must have a
unique IP ID.
Operations & Installation Guide – DOC. 6741C DigitalMedia™ CAT Transmitter 200: DM-TX-200 • 13